RSAG7.820.6217 Software Free Download

RSAG7.820.6217 LED TV Board

RSAG 7.820.6217 is a simple ATV motorist Motherboard intended for TV/ LED TVs. This board is suitable for the Asia Pacific and the Middle East requests. It’s designed to support Full HD TV/ LED Panel defenses. This is a Non-Combo Board. For complete setup, the power input module and LED Backlight Inverter motorist Circuit module are needed independently but ATV Card is erected into this motherboard. This board has all the features and connectivity anchorages as per the rearmost conditions like HDMI input, USB interface, PC input, element Input, television, and Scart( voluntary).

Download Here

Its USB interface can be used to update software/firmware and play multimedia files. It can also support Earphone output. RSAG7.820.6217 is a Full HD-supported LCD LED TV controller board with a maximum resolution of 1920×1080. This board can be installed with 43-inch to 65-inch HD and Full HD LED TV panel screens. Mstar makes the main processor and its graphics are also good. RSAG7.820.6217 firmware files are given below for the technician’s support.

Technical Specifications and General Features:

Brand/Mark: Universal Board

Model: RSAG7.820.6217

Main Chip:

Product: LCD/LED TV

LED Backlight: NA

Flash IC: 4Mb

Sound Chip: NA

Tuner IC: NA

Screen supported: 3-65 inch

Resolution: Up to 1920×1080

Panel Voltage: 5V, 12V

Power Input: 12V DC

Firmware Name: NA

Firmware Type: Backup Dump

Service Code:

Source/Input 2580, Menu 1147

Caution:

All the filmland and specification details related to RSAG 7.820.6217 in this post is for reference only. If you’re a stoner and do n’t have any experience of repairing also it’s better to visit the nearest technician first without loading the software/ firmware. occasionally, the fault is different as per the visual compliances. So, please do n’t try it at home.

Note: The following firmware is USB bootable and a backup file that can be loaded by a programming tool. Kazmi Elecom Team is not responsible for any type of damage/loss as a result of uploading/downloading the firmware. First, check and verify the main board then install software. If you are new and do not have enough knowledge of loading/installing software/firmware or dump files, or facing any issues during firmware installation then visit and read here first. Always keep a backup before writing the flash.